Epiroc EC 60T User Manual

Safety and operating instructions
© Construction Tools PC AB | 9800 1594 01 | 2020-03-23
Original Instructions
17
n
Direct the hydraulic breaker in a position 90° towards
the object.
n
Start near the edge and work your way in towards the
middle. Never start in the middle of large objects.
n
Never run the hydraulic breaker longer than 15sec-
onds on the same spot. Move the working tool to a
new position if the object does not break.
n
Never bend with the working tool.
n
Use the correct feed pressure. When the feed pres-
sure is correct the hydraulic breaker is working at its
best and the vibrations are at a minimum. Also the
wear on the bushing and inserted tool is kept to a
minimum.
n
Listen to the sound from the hydraulic breaker. The
sound changes if there is any bending between the
working tool and bushing.
n
Never run the breaker with the boom cylinders at
their end positions. It may cause damage to the car-
rier.
n
Avoid idling strokes; it causes wear on both working
tool and tool retainers.

Epiroc EC 60T Specifications

General

Brand	Epiroc
Model	EC 60T
Category	Construction Equipment
Language	English