Safety and operating instructions
48 © Construction Tools GmbH | 33905146 01 | 2019-09-05
Original Instructions
7.4.2 Manual lubrication for hydraulic
breakers without ContiLube®II
Manual lubrication is required if no automatic lubrication
system is installed.
n
Place the hydraulic breaker at a right angle on the
working tool and exert pressure.
n
Only use chisel paste for lubrication.
n
Remove the plug from the breaker box.
n
Put the manual grease gun on the grease nipple and
inject chisel paste.
• Lubrication interval: approx. every 2 hours
• 5 to 15 strokes from the manual grease gun
7.4.3 Automatic lubrication
The hydraulic breaker is lubricated automatically by the
ContiLube
®
II.
The ContiLube
®
II has been installed near the service
opening in the upper section of the breaker box.
Instructions on how to operate and maintain the Con-
tiLube
®
II is described in a seperate documentation.
n
If you have questions how to use the ContiLube
®
II,
contact the Epiroc Customer Center / dealer in your
area.
7.4.4 Replacing the lubricant cartridge
n
Unscrew and remove the empty lubricant cartridge
and the old seal by turning counter clockwise.
n
Remove the cover from the new cartridge. Make sure
not to damage the sealing cone(A).
n
Place the seal(B) on the cartridge.
n
Use your thumb to push the cartridge piston down
until lubricant escapes from the screw thread.
n
Screw the cartridge until the stop into the guide hole
of the grease pump.
The ContiLube
®
II is ready for use.
To Next Page
Loading...
Need help?
General
