Registering and deleting projectors for monitoring
11
Registering and deleting projectors for monitoring
This operation is carried out when starting EasyMP Monitor for the first
time after it has been installed and when you would like to add
projectors. Once a projector has been registered, the status for the
projector will be displayed automatically each time EasyMP Monitor is
started from that point onwards.
The operations to register projectors vary as followings depending on
where the projectors are connected to in the network.
• When registering a projector that is located in the same segment as the
computer in which EasyMP Monitor is installed. s "Registering
projectors using automatic search (Searching for and registering
projectors that are located in the same segment)" p.12
• When registering projectors that are in multiple segments of the
network. s "Setting the range of addresses to do an automatic search
and registration" p.14
Starting EasyMP Monitor
Procedure
A Click "Start" - "Programs" (or "All Programs") - "EPSON
Projector" - "EasyMP Monitor Ver.4.40" in that order to start
EasyMP Monitor.
B The main window will be displayed.
The red box area described in the screen below is referred to as
Grouping view.
To Next Page
Loading...
Need help?
General