Installing EasyMP Monitor
9
C From here, continue with the installation by following the
on-screen messages.
Limitations imposed by a Windows Vista or
Windows 7 environment
When using EasyMP Monitor under Windows Vista or Windows 7, note
the following limitations.
• You must have administrator authority in order to use Register at
startup on the Environment setup screen of EasyMP Monitor. s p.27
• If EasyMP Monitor is installed on your computer, uninstall it before
you update the operating system to Windows Vista or Windows 7.
Updating your OS without uninstalling the software may cause a
malfunction. s p.46
Before starting operations
Check the following points before starting up EasyMP Monitor.
• EasyMP Monitor must be installed on the computer to be used for
monitoring and control.
• The computer and the projectors must be connected to the network.
• If using Windows 2000/Windows NT4.0/Windows XP/Windows
Vista/Windows 7, the computer must be started up in Administrator
mode.
• Depending on the projector model, a commercially-available serial W
TCP/IP conversion adapter and a connection cable are required in
order to use EasyMP Monitor. s Projector's User's Guide
Make the settings for the serial W TCP/IP conversion adapter before
connecting to the projector.
To Next Page
Loading...
Need help?
General