E-mail notification of problem/warning/status
37
E-mail notification of problem/warning/status
If the projector experiences a problem or enters a status requiring
attention, an e-mail like that shown below is sent to the address specified
for Recipient mail address.
If there is more than one problem, warning, or status, the corresponding
messages are output to separate lines.
The details contained in the e-mail message can consist of the following.
Item Details shown
E-mail subject [Display name displayed in Grouping view or Detail
list view] Projector status notification
Body <Display name displayed in Grouping view or Detail
list view> has entered the following status.
<Warning/error/status message (Please see the
table below)>
Message Remedy
Internal Error s Projector User's Guide
Fan error
Sensor error
Lamp Cover Open
Lamp failure at power
on
Lamp error
High internal
temperature error
Low air flow error
Air filter air flow
sensor error
High-temperature
warning
Replace Lamp
Replace Air Filter
No Air Filter
Low Air Flow
Air Flow Sensor Err.
Clean Air Filter Notice
No signal No image signals are being received by the
projector. Check the connection status and check
that the power for the connected equipment is
turned on.
To Next Page
Loading...
Need help?
General