Epson EMP MONITOR OPERATION V4.30 User Manual

Operating environment
8
Limitations imposed by a Windows Vista
environment.
When using EMP Monitor under Windows Vista, note the following
limitations.
• You must have administrator authority in order to use Register at
startup on the Environment setup screen of EMP Monitor.
• Even after EMP Monitor has been uninstalled, the settings and log
information will remain on the hard disk. If this information is no
longer required, you may delete the EMP Monitor V4.30 folder.
Provided the default settings were used at installation, this folder can be
found at:
"C:\Users\(User Name)\AppData\Local\VirtualStore\Program
Files\EPSON Projector\EMP Monitor V4.30"
Before starting operations
Check the following points before starting up EMP Monitor.
• EMP Monitor must be installed on the computer to be used for
monitoring and control.
• The computer and the projectors must be connected to the network.
• If using Windows 2000/Windows NT4.0/Windows XP/Windows
Vista, the computer must be started up in Administrator mode.
• Depending on the projector model, a commercially-available serial
TCP/IP conversion adapter and a connection cable are required in
order to use EMP Monitor. s Projector User's Guide "
Make the settings for the serial TCP/IP conversion adapter before
connecting to the projector.

Epson EMP MONITOR OPERATION V4.30 Specifications

General

Brand	Epson
Model	EMP MONITOR OPERATION V4.30
Category	Software
Language	English