Epson EMP MONITOR OPERATION V4.30 Installation Manual

ELPMBUNI
Installation Manual Page - 19 -
Final Adjustments
1. With the projector secured in the mount and power on and signal supplied to the projector you can now
proceed with the final height, tilt, and roll and yaw to optimize the projected image.
2. The height can be adjusted by slightly loosening the two 8mm height adjustment screws and raising or
lowering the projector (Figure 14).
3. Once the height is achieved tighten the two screws.
4. To adjust the tilt angle of the projector, slightly loosen the side M8 screws and tilt to the desired angle to
the screen and firmly tighten the two M8 tilt adjustment screws (Figure 15).
5. If roll adjustment is needed to square the images on the screen, slightly loosen the front and rear M8
screws and adjust to the desired angle then firmly tighten the two M8 roll adjustment screws (Figure 16).
Figure 14
Figure 15
Figure 16
Wood Stud
Ceiling
(Roll) Adjusting
Screws
Allen Wrench
Allen Wrench
Wood Stud
Ceiling
Tilt Adjusting Screws
Wood Stud
Allen Wrench
Height Adjustable
Screws
Ceiling

Epson EMP MONITOR OPERATION V4.30 Specifications

General

Brand	Epson
Model	EMP MONITOR OPERATION V4.30
Category	Software
Language	English