4
Tur ning on and Projecting
• When using the "Direct
Power ON" feature, the
power turns on when the
power cable is connected.
• When using above an
altitude of about 1500 m,
set the "Fan Speed" to
"High".
User’s Guide "Extended
Menu"
● No image is projected ●
■ For notebooks and computers with liquid
(Accessory
Power Cable)
* For video equipment,
press "play" to start
playback.
Control Panel
Remote Control
Power Indicator
crystal displays
Change the computer’s
output source. Hold
down the
key and
press the appropriate
key (the one usually
labelled
/ ). After
changing the setting,
wait a few seconds for
projection to start.
Computer’s "User’s
Guide"
* If the image is not
projected, press
.
■ For video equipment
Start playback then
press
.
Examples
NEC
Panasonic
SOTEC
HP
TOSHIBA
IBM
SONY
DELL
FUJITSU
Macintosh
Set mirror setting
or display
detection.
In this mode pressing has
no effect.
Lit
Flashing
Orange Standby
Press to
start projecting.
Green
Green
Warming up
Wait for a short
time (about 30
seconds).
Projecting
In this mode, you can unplug
the power cable.
Do not unplug the power
cable.
Reading the Indicators
To Next Page
Loading...
Need help?
General
