Epson EX5220 User Manual

Wireless LAN Module Safety Instructions
Follow these safety instructions when setting up and using the wireless LAN module:
• Do not use the device near any medical equipment or cardiac pacemakers. Electromagnetic
interference from the device may cause such equipment to malfunction and cause an accident.
• Use the device only with an Epson projector. If it is installed in another device, such as a computer, it
may cause damage or malfunctions in the other device.
• Do not disassemble or remodel the device; internal components may cause burns.
• Use of the device on aircraft may be restricted in some countries. Before using the device on aircraft,
make sure it is allowed.
• Do not use the device outdoors.
• To comply with RF exposure compliance requirements, at all times maintain a distance of at least 8.7
inches (22 cm) between the antenna of this device and people in the vicinity.
• Do not store the device in direct sunlight, or in locations subject to high temperature or humidity.
• Do not get the device wet.
• Do not use the device near a microwave oven. Electromagnetic interference generated by the
microwave oven may interrupt wireless communication.
• Do not drop the device, subject it to impacts, or place heavy objects on it.
Frequency Precautions
The frequency band for this device is 2.4 GHz. This frequency range is the same frequency bandwidth
as industrial, scientific, and medical devices such as microwave ovens and mobile unit identification (RF-
ID) systems (licensed premises radio stations and unlicensed specified low-power radio stations) used in
factory production lines. Before using this unit, check that there are no radio stations for mobile unit
identification or specified low-power radio station premises nearby. In the event that this unit should
interfere electromagnetically with the premises of a radio station used for mobile unit recognition, cease
use immediately and stop generating the electromagnetic field. Contact Epson if this unit interferes
electromagnetically with a special low-power radio station used for mobile unit identification or causes
similar problems.
Wireless Telegraphy Act Regulations
The following acts are prohibited by the Wireless Telegraphy Act:
• Modifying and disassembling the device (including the antenna)
• Removing the label of conformance
160

Epson EX5220 Specifications

General

Matrix type	3-panel (p-Si TFT active)
Number of colors	1.073 billion colors
Native aspect ratio	4:3
Projection distance	0.9 - 9 m
Projection technology	3LCD
Contrast ratio (typical)	10000:1
Screen size compatibility	30 - 300 \
Projection distance (tele)	9 - 9 m
Projection distance (wide)	0.9 - 0.9 m
Projector native resolution	XGA (1024x768)
Keystone correction, horizontal	-30 - 30 °
Focus	Manual
Throw ratio	1.48 - 1.77:1
Zoom capability	Yes
Focal length range	16.9 - 20.28 mm
Aperture range (F-F)	1.58 - 1.72
Lamp type	UHE
Lamp power	200 W
Lamps quantity	1 lamp(s)
Light source type	Lamp
Service life of light source	6000 h
Service life of light source (economic mode)	5000 h
Full HD	No
Video processing	10 bit
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Supported graphics resolutions	1280 x 1024 (SXGA), 1280 x 800 (WXGA), 1400 x 1050 (SXGA+), 640 x 480 (VGA)
USB connector type	USB Type-A, USB Type-B
USB 2.0 ports quantity	2
Component video (YPbPr/YCbCr) in	0
HDCP	-
Noise level	37 dB
Noise level (economic mode)	29 dB
RMS rated power	2 W
Placement	Desktop, Ceiling
Product type	Standard throw projector
Product color	Black
Cable lock slot type	Kensington
Power source	AC
AC input voltage	100 - 240 V
Voltage tolerance	10 %
AC input frequency	50 - 60 Hz
Power consumption (standby)	- W
Power consumption (typical)	283 W
Power consumption (economy mode)	207 W
Operating temperature (T-T)	5 - 35 °C

Weight and Dimensions

Depth	228.6 mm
Width	294.64 mm
Height	76.2 mm
Weight	2399.5 g