Registering and deleting projectors for monitoring
16
Procedures for registration
Procedure
A Select the projector(s) to be registerd from the displayed list,
and then click "Edit".
The following window will be displayed.
Make the necessary settings while referring to the following table.
Display name Enter the name of the projector(s) to be
displayed in Grouping view or Detail list view.
Up to a maximum of 32 bytes can be entered. A
space cannot be used as the first character.
Display icon Select the icon(s) to be displayed in Grouping
view or Detail list view.
Parent group Select when registering a projector in a group.
If no groups have been created, this cannot be
selected. s "Registering several projectors to a
monitoring group all at once" p.18
Projector
name
This shows the name that has been registered on
the projector.
IP address This shows the IP address for the registered
projector.
Use Serial W
TCP/IP
conversion
adaptor.
This cannot be selected when registering
projectors using automatic search.
Port Number This cannot be selected when registering
projectors using automatic search.
Monitor
Password
If a Monitor Password has been set for the
projector, be sure to enter the Monitor Password
that has been set. If the correct password is not
entered at this time, it will not be possible to
monitor and control the projector even though it
is registered.
Description You can enter some kind of memo about the
projector. The details you enter here will be
displayed at the projector properties.
Up to a maximum of 60 bytes can be entered.
Monitor Select this when you want monitoring to start.
To Next Page
Loading...
Need help?
General