USE
- Plug the appliance to a 220-240V~ 50Hz socket with earthing connection.
- To start the heater, push the -/o switch located at the back of the appliance. You will hear
a "BE BE" sound and the indicator lights up. The machine enters to Standby Mode.
- Push the Stand by button to active the heater.
- There is a tip-over switch inside the heater, it will disconnect the heater automatically if
the machine falls down on the ground.
HEATING
- Press button to choose the power I(1700W), power II(2500W)) , LED or
lights up.
- To turn o your heater anytime press the Stand By Button , the heating element will
stop and the fan will operate for approx 10 seconds allowing your heater to cool down
before switching o.
SWING
- Press Switch on the top panel control when the heater is on, the heater will swing
from left to right with the LED lighting up, Press it again, swing will stop.
- the body sensor and the swing can not use at the same time.
2. INSTALLATION
Your appliance shall be used as portable appliance only (thanks to respect all the safety
warnings given below)
Fix the socle of the appliance by tightening the screw.
Never use the heater without the socle !
Let a minimum distance of 1m between any side of your appliance and any obstacle
(furnitures or walls, for example) to allow a good circulation of the airow.
Always direct the airow in order to optimize the heating of the room.
Avoid the corners, small volumes, wood oors, ceiling, etc…
Warning: this product can be used in bathrooms but only out of the volumes according the
national wiring rules (For France NF C 15-100)
Note: The drawing is for reference only. We suggest that you to contact a professional
electrician for assistance.
3. HOW TO USE
EN
To Next Page
Loading...
Need help?
General