Clipping with hair comb attachment
You may use 5 kinds of comb attachments B for trimming,
1) Put on the desired comb attachment (B1–B7). Then you can turn on the appliance.
2) If you are trimming for the first time, begin by trimming with an attachment of max. length to
prevent too short of a cut. When you have familiarized yourself with the settings, use attachments
B with lower length.
3) You may also use the blade cut length switch A5 for finer cut setting.
4)
Make sure that the flat part of the comb is always in full contact with the scalp to obtain an even result.
5)
Move the clipper slowly over the crown from different directions to achieve an even result.
6) Always move the clipper against the direction of hair growth.
7) Make overlapping passes over the head to ensure that all hair that should be cut has been cut.
8)
Turn the Clipper off and remove the hair comb often to blow and/or shake out hair that has accumulated.
Contouring without the hair clipping comb attachment
1) Remove the hair comb (if it is attached). Be careful when you are clipping without comb
attachment as when the clipper is turned on it will trim every hair it touches.
2) Tilt the clipper in such a way that only one edge of the trimming attachment touches the hair ends
when you shape the contours around the ears.
3) To contour the nape of the neck or hairline, turn the clipper and hold it with the trimming
attachment pointing downwards.
4)
To contour the sideburns, turn the clipper and hold it with the trimming attachment pointing downwards.
Note
You may also use the blade cut length switch A5 for finer cut setting.
Trimming facial hair
1)
Mark a facial hair line with the trimmer and cut off the hairs exceeding this line from the outer perimeter
2) If you want to achieve an even trim of facial hair, use one of the attachments B or trim carefully
the ends by small pieces over the brush in such a way that the brush moves through the hair
upwards. Repeat the process in the whole facial hair area.
3) After trimming shave the parts around the beard in a usual way.
Trimming a mustache
Trim carefully over a brush to achieve an even cut of the mustache. If you prefer using your finger as
a guide, proceed accordingly.
IV. MAINTENANCE
Do not use rough and aggressive detergents! Wipe the trimmer surface with a wet soft cloth.
Cleaning blades (fig. 5)
Clean the blades with the brush attached. For thorough cleaning, the entire trimming head A3 can be
removed. With your thumb, push the A4 blades and remove the trimming head in the direction of the
arrow. When you want to re-attach it, put the plastic projection in the rear part of the trimming head
into the opening in the trimmer and re-attach the trimming head (snap it in).
In order to keep the trimmer in a perfect condition, you have to lubricate the list with blades using one
or two drops of oil for sewing machines (figure 5). Do not use hair oil, petroleum jelly or oil mixed with
petrol or any other solvent because after evaporation the solid parts of the lubricant could slow down
operation of the blades. Insert the trimming head to the trimmer properly, turn on the trimmer and
then turn it off and wipe out the excessive oil from the blades.
Storage
Put the trimmer with the accessories back to the original package at a dry and dust free place, out of
reach of children and incapacitated people.
22
GB
/ 46
To Next Page
Loading...
Need help?
General
