EasyManuals Logo

Euro-Pro Shark 803XC User Manual

Euro-Pro Shark 803XC
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
- 1 -
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic safety precautions should always be
foll
owed, including the following:
Read all instructions before using
(this
sewing machine)
DANGER
To reduce the risk of electric shock:
An appliance should never be left unattended when plugged in. Always unplug this appliance
from the electric outlet immediately after using and before cleaning.
Always unplug before replacing the light bulb. Replace bulb with same type rated 15 watts.
WARNING
To reduce the risk of burns, fire,
electric shock, or injury to persons:
Operate sewing machine only when mounted in sewing machine table, case, and the like. See
the installation instructions.
1. Do not allow to be used as a toy. Close attention is necessary when this appliance is used by
or near children.
2.
Use this appliance only for its intended use as described in this manual. Use only
atta
chments recommended by the manufacturer as contained in this manual.
3.
Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it
has
been dropped or damaged, or dropped into water. Return the appliance to the nearest
authorized dealer or service center
for examination, repair, electrical or mechanical
ad
justment.
4.
Never operate the appliance with any air openings blocked. Keep ventilation openings of the
se
wing machine and foot controller free from the accumulation of lint, dust, and loose cloth.
5.
Never drop or insert any object into any opening.
6.
Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being
adm
inistered.
8.
To disconnect, turn all controls to the off (“0”) position, then remove plug from outlet.
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
10.
Keep fingers away from all moving parts. Special care is required around the sewing machine
ne
edle.
11.
Always use the proper needle plate. The wrong plate can cause the needle to break.
12.
Do not use bent needles.
13.
Do not pull or push fabric while stitching. It may deflect the needle causing it to break.
14.
Unplug the sewing machine when making any adjustments in the needle area, such as
thread
ing needle, changing needle, threading bobbin, or changing presser foot, etc.
15.
Always unplug sewing machine from the electrical outlet when removing covers, lubricating,
or when making any other user servicing adjustments mentioned in the instruction manual.
SAVE THESE INSTRUCTIONS
This sewing machine intended for household use only.
The design and specifications are subject to change without a prior notice.
Rev. 06/08

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Euro-Pro Shark 803XC and is the answer not in the manual?

Euro-Pro Shark 803XC Specifications

General IconGeneral
BrandEuro-Pro
ModelShark 803XC
CategorySewing Machine
LanguageEnglish

Related product manuals