10
7. Adjustments
Seat height
Loosen the fastener at the side of the seat pole (fig.9).
Now, adjust the seat to the required height and fix it
with the fastener (fig.10).
The marked area may not be exceeded (fig.11).
fig.11
Brake lever
Loosen the hexagon socket screw to adjust the brake
lever (fig.1).
The brake lever should be easily accessible for the
driver and should neither be too high nor too low
adjusted (fig.2).
Brake calliper
Loosen the screw nut at the brake calliper (fig.3).
Push the brake arm to its position and pull the Bowden
cable tight.
The brake pad should have a distance of approx. 1mm
left and right to the brake disc (fig.4).
Chain tension
The chain should not be too loose but also not too
tight. It should be moveable (approx. 5-7mm) up- and
downwards (fig.5).
To adjust the chain tension, loosen the screws nuts of
the rear wheel and the hexagon socket screw at the
brake calliper holder (fig.6).
Tighten or loosen the chain with the two chain
tensioner nuts (fig.7).
Tighten the screw nuts of the rear wheel and the
hexagon socket screw. Lubricate the chain with some
chain oil or chain grease (fig. 8).
fig.2
fig.8 fig.7
To Next Page
Loading...
General