30
Using Your Evinrude E-TEC Outboard
ENGINE STARTING / STOPPING -
REMOTE CONTROL MODELS
Refer to the Pre-Ride Inspection on page 49.
Complete the inspection before using your
Evinrude E-TEC outboard.
You MUST supply water to the
engine before attempting to start it.
Engine damage can occur quickly.
Be sure the water intake screens are below
the water surface.
Connecting the Fuel Hose
Connect the fuel hose to the fuel connector.
If equipped, open vent screw on fuel tank cap.
Squeeze fuel primer bulb, outlet end up, until
firm.
Engine Cut–off Switch/Key Switch
A combination engine cut–off switch and key
switch is a feature of Evinrude prewired re-
mote controls and all Evinrude control wiring
kits. Use of the engine cut–off feature is highly
recommended on all boats.
Connect the clip to the engine cut–off stop/
key switch.
In an emergency situation, the engine can be
started without the clip in place. Follow the
normal starting procedure. Reinstall a clip as
soon as possible. The operator should al-
ways use the clip and tether cord anytime
the engine is running. Refer to Engine Cut–
off Switch/Key Switch on page 30.
IMPORTANT: Your engine cut–off switch can
be effective only when in good working condi-
tion. At each outing, inspect clip and tether
cord for cuts, breaks, or wear. Replace worn
or damaged parts.
Snap the tether cord to a secure place on the
operator’s clothing or life vest — not where it
1. Fuel connector
007004
1. Clip
2. Engine cut–off/key switch
3. Tether cord
DR6819
DR5992A
A WARNING
Always use the tether cord when operat-
ing your boat to help prevent a runaway
boat and reduce the risk of personal
injury or death.
To Next Page
Loading...
Need help?
General
