Page
16
3.7.2 Printer Font Commands – Courier Character Set:
Font Name Character size (W x H) Command String
24 CPI normal 8x23 ESC+'k'+'5'
21 CPI normal 9x23 ESC+'k'+'4'
19 CPI normal 10x23 ESC+'k'+'3'
16 CPI normal 12x23 ESC+'k'+'2'
12 CPI normal 16x23 ESC+'k'+'1'
13 CPI rotated 14x16 ESC+'k'+'0'
3.7.3 Printer Font Commands
:
Command String Printer Action
ESC - ‘F’ – 1 Selects International character set
ESC - ‘F’ – 2 Selects PC Line Draw character set
ESC - ‘U’ - ‘1’ Enable emphasized print.
ESC - ‘U’ - ‘0’ Disable emphasized print.
3.7.4 Printer Graphic Commands:
Command String Printer Action
ESC - ‘a’ – n Select dot line spacing between printed lines.
ESC - ‘J’ – n Graphic Line Feed command
ESC - ‘P’ - ‘#’ Select Online mode, characters printed as received.
ESC - ‘P’ - ‘$’ Select Buffer mode, characters are printed on (^ D)
ESC - ‘V’ - n1 – n2 8-bit Graphic command
ESC - ‘v’ - n1 – n2 RLE Compressed Graphic command
3.7.5 Magnetic Card Reader Control Commands:
Command String Printer Action
ESC - ‘M’ - ‘nnm’ - Cr Select MCR with (nn) auto timeout
ESC – ‘C’ Cancel MCR read process
3.7.5.1 Smart Card Reader Control Commands (when SCR is installed):
Command String Printer Action
ESC - ‘M’ - ‘nn’ - ‘7’- Cr Select SCR in direct mode with
Serial RS232 (UART0). (nn) is the
auto timeout of the SCR.
ESC - ‘M’ - ‘nn’ - ‘8’- Cr
Select SCR in PassThru mode with
BT/802.11 or IrDA on (UART1).
(nn) is the auto timeout of the SCR.
To Next Page
Loading...
Need help?
General