GB-13GB-12
For detailed operating method read the corresponding content on the instruction
manual.
QUICK OPERATION GUIDE
Switch on the
appliance
Press the Power switch button to switch on the appliance,
Open the door.
Fill the detergent
dispenser
Compartment A:
With each wash cycle.
Compartment B:
For programmes with pre-wash only.
(Follow the user instructions!)
Check the rinse
aid level
Mechanical indicator C.
Electric indicator on control panel (if provided).
Check the
regeneration salt
level
(On models with water softener system only.)
Electric indicator on control panel (ifprovided).
If there is no salt warning light in
thecontrol panel (forsomemodels),
youcan estimate when to ll the salt
intothe softener by the number of
cyclesthe dishwasher has run.
Load the baskets
Scrape o any large amount of leftover food. Soften remnants
of burnt food in pans, then load the baskets. Refer to the
dishwasher loading instructions.
Select a
programme
Close the door. Press the programme button until the
selected programme lights up. (See the section entitled
“Operation instruction”)
Running the
dishwasher
Turn on the water tap and press the Start/Pause button. e
machine will start working after about 10 seconds.
• Changing the
programme
1. A running cycle can only be modied if it has been running
for a short time. Otherwise the detergent may have already
been released and the water already drained. If this is the
case, the detergent dispenser must be relled.
2. Press the Start/Pause button .then press the program
button more than 3 seconds to cancel therunning
programme.
3. Select a new programme.
4. Restart the dishwasher.
• Add forgotten
dishes in the
dishwasher.
1. Press the start/pause button
to stop the machine.
2. Open the door.
3. Add the forgotten dishes.
4. Close the door, then press
the start/pause button,
thedishwasher will start running again after 10 seconds.
• If the appliance
is switched o
during a wash
cycle.
• If the appliance is switched o during a wash cycle, when
switched on again, please re-select the washing cycle and
operate the dishwasher according to the original Power-on
state).
Switch o the
appliance
When the working cycle has nished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn o the appliance using the Power button.
Since the appliance is standing by, it will power o
automatically after 30 minutes without any operation.
Turn o the water
tap, unload the
baskets
Warning: wait a few minutes (about 15 minutes) before
unloading the dishwasher to avoid handling the dishes and
utensils while they are still hot and more susceptible to break.
ey will also dry better. Unload the appliance, starting from
the lower basket.
WARNING!
Open the door
carefully. Hot steam
may escape when the
door is opened!
To Next Page
Loading...
Need help?
General
