GB-29GB-28
Filtering System
e lter system consists of a coarse lter, a at (Main lter) and a micro lter (ne lter).
Filter assembly
e lter eciently removes food particles from the wash water, allowing it to be
recycled during the cycle.
For best performance and results, the lter assembly must be cleaned regularly. For
this reason, it is a good idea to remove the larger food particles trapping in the lter
after each wash cycle by rinsing the lter and cup under running water. To remove
the lter assembly, pull the cup handle in the upward direction.
e lter system consists of a coarse lter, a
at (Main lter) and a micro lter (ne lter).
A
Main lter: is lter holds soil and
food residues in the sump area and prevents
it from being redeposited on the dishes
during a cycle.
B
Fine lter: is lter holds soil and food
residues in the sump area and prevents it from
being redeposited on the dishes during a cycle.
C
Coarse lter: Larger items, such as
pieces of bone or glass, that could block
the drain are trapped in the coarse lter.
To remove the items caught by this lter,
gently squeeze the tap on the top of this
lter and lift it out.
WARNING!
Never run the dishwasher without the lters in place.
e dishwasher must never be used without the lters.
Improper replacement of the lter may reduce the performance
level of the appliance and damage dishes and utensils.
MAINTENANCE AND CLEANING
Step 1: Contrarotate the lter assembly
(A,B and C), then lift it all up.
B
Step 2: Lift B and C up from A;
Step 3: Separate B and C.
NOTE:
If do it from step 1 to step 3, the lter system will be removed; while
if do it from Step 3 to Step 1, the lter system will be installed.
NOTE:
e entire lter assembly should be cleaned once a week.
Remarks:
• Inspect the lters for blocking every time the dishwasher has been used.
• By unscrewing the coarse lter. you can remove the lter system. Remove any food
remnants and clean the lters under running water.