10 CT Series Dust Extractors
AutoClean Setup
The CT-AC series of vacuums have the optional AutoClean
function. When enabled, the AutoClean function sends a
page 7.
The purpose of the AutoClean function is to circumvent the
dusts are collected. Therefore, the AutoClean function is
(Even though a bag could be installed, it would diminish
the effect of AutoClean.) To aid in emptying the collection
canister, a dust liner is recommended.
For AutoClean mode, it is recommended to use the CT
-
AutoClean function is disabled.
Manual
Clean
Frequency
Dial
Off
Min
Max
Non-AutoClean Mode
The CT-AC vacuum may be used as a typical shop and
household vacuum by disabling the AutoClean feature and
-
Manual AutoClean Mode
A manual cleaning cycle may be initiated by turning the
positions momentarily. The vacuum will produce several
AutoClean pulses in succession. A manual AutoClean cycle
should be performed periodically to perform a deeper clean-
performed prior to emptying the collection canister.
before the cleaning cycle to provide the deepest cleaning.
inlet without having to disconnect the hose or the tool.
Optional
Blast Gate
Open
Close
1. Block the inlet to the vacuum or the end of the hose.
2. Momentarily rotate the power switch to either of the two
position.
3. After the vacuum has stopped pulsing, unblock the inlet.
Automatic AutoClean Mode
AutoClean cycles without interrupting the operation of the
vacuum, with only a brief reduction in suction at the hose.
The frequency of the AutoClean pulses is controlled by turn-
ing the frequency dial. Turning the dial clockwise increases
the frequency of the pulses, and turning the dial counter-
clockwise decreases the frequency. Turning the dial all the
way counterclockwise will disable the automatic AutoClean
system.
Using Dust Liners
Dust liners are not bags, but are open-faced to line the bot-
tom of the collection canister to make emptying the canister
easier. The liners have two vents on the side. These are not
would otherwise be trapped under the liner, and allow the
Changing the dust liner is similar to changing a collection
Changing Collection Bags” on page 8 for
additional details.
1. Place the liner in the bottom of the collection canister and
-
ner as a collection bag.
2. Wrap the edges of the liner around the lip of the collec-
tion canister, so that when the motor housing is replaced,
it holds the liner in place.
► Make sure the 3 electrical contacts near the vacuum
inlet are not covered by the plastic liner. The center
electrical contact is the grounded connection for the
anti-static hose.
►
the vent panels are not inside the canister, the dust liner
will balloon up when the vacuum is turned on.
3. When emptying the full liner, use the attached tie wrap to
seal the top of the liner.
Anti-Static
Connector
Vent
Panels
Wrap Liner
Around Edges
To Next Page
Loading...
Need help?
General
