Contents
1 Safety instructions.................................... 13
2 Symbols..................................................... 13
3 Parts of the machine.................................14
4 Technical data........................................... 14
5 Intended use..............................................14
6 Commissioning..........................................15
7 Settings......................................................16
8 Working..................................................... 17
9 Service and maintenance..........................18
10 Environment..............................................18
1 Safety instructions
Warning! Read and observe all informa
tion and safety instructions. Failure to observe
the information and safety instructions may
lead to electric shocks, fires and/or serious in
juries.
Keep all safety information and instructions
for future reference.
– This appliance must not be used by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge. Children need
to be supervised to ensure they do not play
with the device.
– If the mains power cable is damaged, it
must be replaced by an authorised service
workshop to prevent it posing a risk.
– Warning Operators must be appropriately
instructed in the use of this machine.
– The mains plug must always be disconnec
ted from the socket before performing
cleaning or maintenance tasks, when re
placing consumables or when converting
the machine.
– Warning Only use the electrical outlet
module on the machine for the purposes
specified in the instructions.
– Warning If foam or fluid starts to escape,
switch off the machine immediately.
– Caution Regularly clean the water level
limiting device and inspect it for signs of
damage.
– Sound pressure level as per EN
60335-2-69/uncertainty K
70 dB(A)/3 dB
– Hand-arm vibration value as per EN
60335-6-69/uncertainty K
< 2.5 m/s² / 1.5 m/s²
– Warning Device may contain hazardous
dust. Only have the device maintained and
emptied, and only have the filter replaced
by an authorised specialist using suitable
protective equipment.
– Always operate with the filter system in
stalled!
– Risk of explosion and fire: Do not extract:
– Sparks or hot dust;
– combustible or explosive materials (e.g.
magnesium, aluminium, petrol, diluting
agents);
– aggressive materials (e.g. acid, alkaline
solutions, solvents);
– chemically reactive materials, which
lead to the generation of heat, acids/
bases, gases, etc. (e.g. reactive two-
component materials, aluminium and
water).
– Observe all national safety regulations as
well as the material manufacturer's speci
fications!
– Always use suitable protective equipment!
– If intact following a visual inspection, work
in a dry environment according to instruc
tions!
– Check the plug and the cable regularly in
order to prevent a hazard. In the event of
damage, these must be replaced by an au
thorised service workshop only.
– Do not lift or transport the device using a
crane hook or lifting gear.
2 Symbols
Warning of general danger
Risk of electric shock
Read the operating instructions/notes.
Wear a dust mask.
Warning! The machine may contain
hazardous dust!
Suitable for separation of dust
with an exposure limit value
greater than 1 mg/m
3
English
13
To Next Page
Loading...
Need help?
General
