– 14 –
SYSTEM OVERVIE
SYSTEM OVERVIESYSTEM OVERVIE
SYSTEM OVERVIEW
WW
W
About the Display and Indicators
Display Definitions (for other displays, see Trouble Messages)
Alarm: Displayed when the system is armed and an intrusion has been detected
(also appears during a fire alarm or audible emergency alarm).
Accompanied by the protection zone that is in alarm.
Armed Away: All burglary zones, interior and perimeter, are armed.
Armed Stay: Perimeter burglary zones, such as protected windows and doors, are
armed.
Exit Now: Displayed during exit delay
Disarmed Ready to Arm: Displayed immediately after system has been disarmed.
Disarmed Ready: Displayed when the system is disarmed and is ready to be armed.
Disarmed NotReady: Displayed when the system is disarmed but is not ready to be armed
AwayInst or StayInst: Entry delay is turned off.
UL
ULUL
UL
ReadyGuard Plus is not intended for UL985 Household Fire applications unless a 24-hour backup
battery (P/N LYNXRCHKIT-HC or LYNXRCHKIT-SHA) is installed.
Fire: Displayed when a fire alarm or fire fault is present. Accompanied by a
display of the zone that is in alarm.
LowBat: Low battery condition exists in a wireless sensor (if zone number is
displayed) or low system battery (if no zone number is displayed). If 00 is
displayed, a wireless keypad (5827) has a low battery condition.
No AC: Displayed when AC power is NOT present. If displayed, the system is
operating on backup battery power.
Chime: Displayed when the Chime feature is enabled and the system is
disarmed.
Test in Progress: Displayed when the system is in Test mode.
Record Press Off to Stop: Displayed when the system is in Recording mode.
Msg: Displayed when a message has been recorded and has not yet been
played back.
Bypass: Displayed when one or more burglary protection zones have been
bypassed.
Fault: Displayed at any time a malfunction is discovered in the system; or any
time an open is detected in a fire zone; or when a fault in a day/night
burglary zone is discovered during a disarmed period. Accompanied by a
display of the zone number in trouble.
PH Speakerphone: Displayed in place of the clock when the speaker phone mode is active.
PC Remote Phone: Displayed during a remote phone control session.
To Next Page
Loading...
Need help?
General
