29
WATER FILTER (ICE & WATER MODELS ONLY)
EN
All the water to your refrigerator is filtered to remove impurities through a filter
cartridge located in a position of your choice outside the refrigerator. This will need
changing approximately every 6months.
There is a replacement indicator icon on the internal control panel and external
display which will appear when the filter needs replacing. It will flash, as a reminder,
when water is dispensed.
Replacement filter cartridges are available from your Fisher & Paykel Authorized Service
Agent. The details of the replacement filter cartridge are labelled on the cartridge.
Changing the water filter cartridge
It is not necessary to turn off the water supply before attempting to change the water
filtercartridge.
1
Grasp and firmly twist the cartridge in an anticlockwise direction (to the left when
installed in the recommended orientation).
2
Pull the cartridge away from the filter head (down when installed in the recommended
orientation).
– It is not unusual for a few drops of water to be present when the filter is removed.
3
Discard the old filter.
4
Filter installation:
– Remove protective cap on spigot on head.
– Push the cartridge up towards filter head while rotating it in a clockwise direction
(to the right when installed in the recommended orientation).
5
Reset filter indicator icon on the display (this will remind you when the filter is due to be
replaced again).
6
To flush the water filter of any trapped air, harmless carbon fines and to also check for
leaks, disconnect the tubing from the back of the refrigerator, aim the end of the tubing
into a bucket, turn isolating tap on and run at least 10qt (10liters) of water through.
Once complete turn isolating tap off. Reconnect the tubing.
7
A few drips may appear out of the dispenser over the next few days as the remaining
trapped air is cleared.
Changing the water filter cartridge
1 2 4
To Next Page
Loading...
Need help?
General
