19
SANITIZE
Using SANITIZE
The SANITIZE wash modifier adjusts the wash program to meet the conditions required by
Section 6, NSF 184 for sanitization to occur. While SANITIZE is running, the wash program is
monitored to ensure that these conditions are met.
Only programs utilising the
SANITIZE wash modifier are certified to meet the conditions
required by Section 6, NSF 184. Other wash programs may not reach the temperatures
required for sanitization to occur. Refer to 'Wash modifiers' for wash programs that have
sanitize available.
For sanitization to occur, the temperature of the water needs to reach 158°F (70°C). Ensure
all items are dishwasher safe before running the sanitize modifier.
If the wash is interrupted or the water supply is turned off during the program, the heating
conditions for sanitization may not be met. You may need to run the program again.
If sanitization has been successful
The wash will finish as normal.
If sanitization has not been successful
An alert will sound and a code will show on
the display.
1 Check if the water supply has been turned
off or the wash program interrupted.
2 Press and hold
to stop the beeping,
then again to clear the alert code.
3 Reset
SANITIZE and run the cycle again
For more information, refer to 'Fault codes'.
To Next Page
Loading...
Need help?
General
