5
4. Sound
Rods
Two different sizes are included with the XLT-30. Rods give the user vari-
ous lengths for direct or indirect contact to pipes.
5. T-Handle
This handle is used primarily with the Cylinder Probe and the sound
rods.
5A. Multi-Sensor Handle
This handle is used with the Multi-Sensor
6. Headphones
These headphones are designed to deliver the clearest sound with the
least distortion. The Volume knob can be used to adjust the audio level.
Unplugging the headphones will turn off the XLT-30. When the XLT-30 is
turned off, any modications to the Volume, Notch, and Filter will return
to the factory presets.
7. Probe Cable (Option A & C)
This cable attaches at the back of the Control Housing to any of the
various probes. Make sure the jack is fully inserted and the lock nut is
hand tightened.
8. Carrying Strap/Housing Mounting Bracket
The attachment system for the XLT-30 consists of a plastic mounting
bracket that slides from the bottom of the control housing up to the bezel
around the faceplate. There are two slots for attaching an adjustable
strap that hangs around the neck of the user.
INSTRUMENT SET
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General