Fisher FIELDVUE DVC6200 Mounting Instructions

1
DVC6200/DVC2000
Digital Valve Controller on
Linear Actuator
Mounting Instructions
D103996X012
May 2014
Use these instructions to mount a FIELDVUE™
DVC6200/DVC2000 to a Linear Actuator.
WARNING
Avoid personal injury or property
damage from sudden release of process
pressure or bursting of parts. Before
performing any maintenance
operations:
 Always wear protective clothing,
gloves, and eyewear.
 Do not remove the actuator from
the valve while the valve is still
pressurized.
 Disconnect any operating lines
providing air pressure, electric power, or
a control signal to the actuator. Be sure
the actuator cannot suddenly open or
close the valve.
 Use bypass valves or completely
shut off the process to isolate the valve
from process pressure. Relieve process
pressure from both sides of the valve.
 Vent the pneumatic actuator
loading pressure and relieve any
actuator spring precompression.
 Use lock-out procedures to be sure
that the above measures stay in effect
while you work on the equipment.
 Check with your process or safety
engineer for any additional measures
that must be taken to protect against
process media.
The visual aids in this document are for general
reference representation only. Refer to the
appropriate actuator instruction manual for actuator
installation, operation, maintenance, and parts
identification as this manual
may or may not include
all components shown for kit installation
.
1. Isolate the control valve from the process line
pressure and release pressure from both sides of the
valve body. Shut off all pressure lines to the actuator,
releasing all pressure from the actuator. Use lock-out
procedures to be sure that the above measures stay in
effect while you work on the equipment.
2. Attach connector arm assembly to stem block
using provided fasteners (including spacers and stud
bolts, if applicable).

Fisher FIELDVUE DVC6200 Specifications

General

Brand	Fisher
Model	FIELDVUE DVC6200
Category	Controller
Language	English