Ford 1997 Expedition User Manual

Replacing tail lamp/backup
lamp bulbs
The tail lamp/backup lamp
assemblies are located in the same
portion of the vehicle rear, one just
below the other. Follow the same
steps to replace either bulb:
1. Open the liftgate to expose the
lamp assemblies.
2. Remove the two screws at the
top of the lens.
3. Carefully pop the lens off and to
the right (it may be necessary to
use a screwdriver to remove the
lens).
4. Twist the connector
1
⁄ 4 turn
couterclockwise and pull it out for
replacement.
5. Pull the bulb straight out of the
recess and replace it.
6. Replace the lens and secure the
two screws.
Replacing license plate lamp
bulbs
The license plate bulbs are located
under and behind the rear bumper.
To change the license plate lamp
bulbs:
1. Reach under and behind the
rear bumper to locate the bulb
connector.
2. Twist the connector
counterclockwise
1
⁄ 4 turn and
carefully pull to remove it.
3. Pull out the old bulb and press
in the replacement bulb.
exd_license_plate_lamps
Maintenance and care
204

Ford 1997 Expedition Specifications

General

Brand	Ford
Model	1997 Expedition
Category	Automobile
Language	English