Using automatic locking mode
The automatic locking mode must
be used when installing a child
safety seat in any outboard
passenger seat.
1. Buckle the combination lap and
shoulder belt.
2. Grasp the shoulder belt portion
and pull downward until the entire
belt is extracted.
3. Allow the belt to retract. As the
belt retracts, you will hear a
clicking sound. This indicates that
the safety belt is now in the
automatic locking mode.
Canceling automatic locking
mode
Disconnect the combination lap
and shoulder belt and allow it to
completely retract. This will cancel
the automatic locking mode and
activate the vehicle sensitive
(emergency) locking mode.
Adjusting the lap belt
A lap belt is located in the center
of the rear seat and third row seat
(if equipped).
Because the lap belt does not have
a retractor to automatically adjust
itself during vehicle movement, the
lap belt must be adjusted before
use.
exd_canceling_auto_locking_mod
exd_adjusting_lap_belt
Seating and safety restraints
83
To Next Page
Loading...
Need help?
General
