REMOVAL AND INSTALLATION
Engine Assembly, Aerostar
Removal
1. Disconnect positive and negative battery cables from battery terminals. Remove the retaining bolt
from battery cable support-to-frame bracket at left front of engine. Secure cables to engine (6007).
2. Loosen radiator drain cock and drain coolant from radiator. Refer to Section 03-03 .
3. Disconnect PCV closure hose at engine air cleaner outlet tube. Release clips retaining air cleaner
top. Loosen air cleaner outlet duct clamp at throttle body (9E926) and remove air cleaner top and air
cleaner outlet tube together.
4. Remove vacuum supply hoses from:
a. Power brake booster.
b. Cruise control at check valve near throttle linkage (if equipped).
c. Manifold absolute pressure sensor (MAP sensor).
d. Heater and air conditioner supply hose at A/C vacuum check valve near A/C vacuum reservoir
tank and bracket.
5. Secure vacuum hoses to engine.
6. Remove upper radiator hose and lower radiator hose.
Section 03-01B: Engine, 3.0L V-6 1997 Aerostar, Ranger Workshop Manual
SPECIAL SERVICE TOOL(S)
REQUIRED
Description Tool Number
T84T-6312-C
Fan Clutch Nut Wrench T84T-6312-D
Clutch Coupling Tool T88T-70522-
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVK31B39.HTM~gen~ref.HTM
To Next Page
Loading...
Need help?
General
