Before placing the jack under the vehicle, NOTE the jack location
markings:
JACK LOCATION
The jack location markings can be
found on the lower outer edge of
the body.
• Locate the jack locator mark (B)
on the body (C) near the tire you
are changing, then place the jack
(D) under the frame (A) of
the vehicle aligning it with the
mark (B).
• Position the jack according to the
following guides and turn the jack
handle clockwise until the wheel
is completely off the ground.
WARNING: To lessen risk
of personal injury, do not
put any part of your body under
the vehicle while changing a tire.
Do not start the engine when your
vehicle is on the jack. The jack is
ONLY meant for changing the tire.
• Never use the rear differential as a jacking point.
4. Remove the metal lug nuts with the lug wrench.
5. Replace the flat tire/wheel assembly with the spare tire/wheel
assembly, making sure the valve stem is facing outward. Reinstall lug
nuts until the wheel is snug against the hub. Do not fully tighten the lug
nuts until the wheel has been lowered.
A
D
B
C
Roadside Emergencies
204
2011 Crown Victoria (cro)
Owners Guide, 1st Printing
USA (fus)
To Next Page
Loading...
Need help?
General
