If the traffic signal weakens, ‘TP’ or
‘TP LOST’ will flash in the display and
on some units a beep will be heard.
Press the SEEK button or, the
left/right arrow buttons to find
another station. Some units will
automatically retune to another traffic
station.
If a non-traffic station is selected or
recalled using a preset button, the
audio unit will remain on that station
unless:
• TA is turned off, then on again.
• On certain models, the volume
control is set to zero for four
minutes after which the audio unit
will retune to another traffic
station.
Local or distant traffic
The number of RDS (EON-) traffic
announcements may become
excessive in some areas so there is
an option on some units to select
between local traffic information and
all available information.
Sony CD/6CD
• Press the MENU button and use
the up/down arrow buttons to
select a TA display.
• Use the left/right arrow buttons to
select the setting required.
• Press the MENU button to confirm
your selection.
All other units except Sony
CD/6CD and 2050
• Press and hold the MENU button
until the display changes.
• Press the MENU button
repeatedly until a TA display
appears.
• Use the SEEK or left/right arrow
buttons to select either local
(‘TA-LOCAL’) or distant (‘TADIST’)
traffic announcements.
• ‘TA-L or ‘TA-D’ appear in the
display to show which has been
selected.
2050
On 2050 units the radio is permantely
set on distant traffic annoucments.
Traffic announcement
volume
Traffic announcements interrupt
normal broadcasts at a preset
minimum level that is usually louder
than normal listening volumes.
To adjust the preset volume on all
units except 2050:
• Press and hold the TA button.
• Use the volume control or, on
Sony units, the up/down arrow
buttons to make the necessary
adjustment. The display will show
the level selected.
To adjust the volume on 2050:
• When the traffic announcment is
broadcasting adjust the volume
using the volume up/down
buttons.
18
Audio unit operation
To Next Page
Loading...
Need help?
General
