7
8
13/19
BEDSLIDE.COM | 888.807.0099
INSTALLATION
LOOSEN AND REMOVE CENTER BED BOLTS
Loosen and remove the center bed bolts using a ratchet with a EP-24 torx socket.
Loosen per manufacture specs. If your truck bed is equipped with a spray in liner you will need
to cut around the head of each bolt with a utility knife to break the bed bolts free.
Discard the bed bolts.
Removal of all 4 bed bolts will allow DO NOT REMOVE ALL 4 BED BOLTS AT ONCE!
the bed to move out of alignment. This will make it difficult to re-install the bed bolts.
UTILITY KNIFE
EP-24 TORX SOCKET
EP-24
TOP VIEW
REMOVE SPRAY IN LINER MATERIAL
If your bed is equipped with a spray in bed liner you must cut and remove the
material around the bed bolt. A 3 1/2” x 3 1/2” square is sufficient.
UTILITY KNIFE
3 1/2”
3 1/2”
CAB
To Next Page
Loading...
Need help?
General
