FEATURE SETUP
STICKER SETUP
MAKE SURE YOU HAVE THE FOLLOWING ITEMS:
ONE-TIME SETUP
Once you input your trailer’s information into the touchscreen, it is stored for easy recall. That way, when you
want to use the Pro Trailer Backup Assist with Trailer Reverse Guidance system to help you back your trailer into
your desired position, you can choose it from the touchscreen. You will not have to run through this setup again
unless you want to add another trailer. You can store information for up to 10 trailers within this feature.
Tape measure
(English or metric)
For more information about your
vehicle, please scan the QR code below
This guide with the sticker placement card and
the stickers in the inside back cover pocket
Note: Once your truck receives the vehicle system update that enables sticker setup, it will default to sticker setup. To set up a trailer with the sensor, you must
install the sensor on the trailer and plug it into the vehicle prior to beginning setup on the touchscreen.
Place the entire sticker in the green zone on the trailer as outlined
in the diagram on the next page. The sticker is in the back cover
pocket of this guide.
MAKE SURE YOU GATHER THE FOLLOWING ITEMS BEFORE
EXITING THE VEHICLE:
PLACING THE STICKER
Rear view
camera
Sticker and sticker placement card
(provided inside the back cover pocket of
this guide).
Tape measure
(not provided).
9
10
owner.ford.com
To Next Page
Loading...
Need help?
General
