14
OPERATION
• To avoid recoil, pull starter cord slowly until resistance is felt, then pull rapidly.
WARNING!
Pull cord recoils rapidly and pulls arm towards engine faster than you can let go which
could result in injury.
Note: To start the generator with the Economy switch in the “ON” position
• Disconnect all electrical loads from generator.
• If ambient temperature is below 32ºF (0ºC) allow about 3 minutes for the engine to warm up.
• The Economy is in “ON” position, the unit returns to normal operation after the above warm up time.
• Economy switch must be turned to the “OFF” position when using electronic devices that require a large starting current,
such as a compressor.
Stopping The Inverter
During normal operation, use the following steps to stop your inverter:
1. Remove any connected loads from the control panel receptacles.
2. Allow the inverter to run at “no load” to reduce and stabilize engine and alternator temperatures.
3. Move the Fuel Control Switch to the OFF position, press the push button.
To Next Page
Need help?
General
