MINA
MAXB
ENGINE OIL CHECK
Check the level before starting the engine
and make sure that the level is between
the MIN and the MAX marks.
1. Make sure that your vehicle is on level
ground.
2. Switch the engine off and wait 10
minutes for the oil to drain into the oil
pan.
3. Remove the dipstick and wipe it with
a clean, lint-free cloth. Replace the
dipstick and remove it again to check
the oil level.
If the level is at the MIN mark, add oil
immediately.
Adding Engine Oil
Note: Do not remove the filler cap when
the engine is running.
Note: Do not add oil further than the MAX
mark. Oil levels above the MAX mark may
cause engine damage.
Only use oils certified for gasoline engines
by the American Petroleum Institute (API).
An oil with this trademark symbol
conforms to the current engine and
emission system protection standards and
fuel economy requirements of the
International Lubricants Specification
Advisory Council (ILSAC), comprised of
U.S. and Japanese automobile
manufacturers.
1. Remove the filler cap.
2. Add engine oil that meets the Ford
specifications. See Capacities and
Specifications (page 310).
3. Replace the filler cap. Turn it until you
feel a strong resistance.
Engine Management Mode (If Equipped)
The engine management mode is
equipped on Energi models only. The
engine management mode keeps the
engine oil quality in good condition when
you drive your vehicle with limited engine
use. If your vehicle is in engine
management mode when you start the
vehicle, a message will appear in the
information display. When your vehicle is
in engine management mode, your vehicle
will run the engine as necessary.
255
Fusion/Mondeo (CC7), enUSA
Maintenance
To Next Page
Loading...
Need help?
General
