Activating/deactivating collision warning system
To turn the warning system and/or chime on or off and set the warning
sensitivity <– –>, refer to Message center in the Instrument Cluster
chapter.
Note: If the system cannot be turned off in a MyKey™ equipped vehicle,
refer to MyKey™ in the Locks and Security chapter for more
information.
Note: If collision warnings are perceived as being too frequent or
disturbing then the warning sensitivity can be reduced, though the
manufacturer recommends using the highest sensitivity setting where
possible. Setting lower sensitivity would lead to fewer and later system
warnings. Refer to the Message center in the Instrument Cluster
chapter for instructions on reducing the sensitivity.
BLIND SPOT INFORMATION SYSTEM (BLIS姞) WITH CROSS
TRAFFIC ALERT (CTA) (IF EQUIPPED)
The BLIS威 is a convenience feature
that aids the driver in assessing
whether a vehicle is within an area
on either side of the vehicle
extending rearward from the outside
mirrors to approximately 10 feet
(3 meters) beyond the bumper. This
area is referred to as the blind zone.
The BLIS威 will alert the driver to
the presence of motorized vehicles
in these areas while driving on roads
and freeways.
The system is not designed to
prevent contact with other vehicles
or objects. The system is designed
to provide a warning to assist the
driver in detecting vehicles in the blind zones. The system will not detect
infrastructure, pedestrians, or cyclists.
WARNING: To help avoid injuries, NEVER use the BLIS威 as a
replacement for using the side and rear view mirrors and looking
over your shoulder before changing lanes. BLIS威 is not a replacement
for careful driving and only an assist.
Driving
270
2010 Taurus (500)
Owners Guide, 3rd Printing
USA (fus)
To Next Page
Loading...
Need help?
General
