38
Fortress S-Series
15.0 Specification Sheets (EN 12184 & ISO 7176-15)
Sunrise Medical Canada Inc.
237 Romina Drive, Unit 3
Concord, ON
L4K 4V3
Phone: 1-800-263-3390
Fax: 1-800-561-5834
www.SunriseMedical.ca
Operating temp: -25°C to 50°C
Storage temp: -40°C to 65°C
Moisture resistance: IPX4
No restrictions on humidity and air pressure.
Maximum occupant mass:
S425 = 150 kg, S700 = 160 kg
The Fortress S-series scooters conform to the following
standards:
a) requirements and test methods for static, impact and
fatigue strengths (ISO 7176-8)
b) power and control systems for electric wheelchairs
requirements and test methods (ISO 7176-14)
c) climatic test in accordance with ISO 7176-9
d) requirements for resistance to ignition in accordance
with ISO 7176-16
e) the product is specified as a Class B, (S425), Class C,
(S700), power product
f) all materials used on this product conform to EN1021
parts 1 and 2
NOTE:
• See charts on following pages.
• Measurements of upholstered parts are approximate.
All other measurments may be subject to change.
CAUTION!
This scooter has not been tested to ISO 7176-19 for use
as a seat when travelling in a vehicle.
13.0 Disposal
The symbols below mean that, in accordance with local
laws and regulations, your product should be disposed of
separately from household waste.
When this product reaches the end of its life, take it to the
local collection point designated by local authorities. The
separate collection and recycling of your product at the
time of disposal will help conserve natural resources and
ensure that it is recycled in a manner that protects the
environment.
NOTE: Ensure you are the legal owner of the product prior
to arranging for the product disposal in accordance with
the above.
14.0 Torque Settings
WARNING!
• Do not attempt to dismantle and/or reassemble the
scooter on an engineering level, or fit any replacement
parts or accessories if you are not qualified/authorized
to do so.
• Always consult your approved Sunrise Medical
servicing agent.
The torque information supplied below will enable normal
routine maintenance tasks to be performed, (please also
see Section 18).
GENERAL TORQUE SETTINGS
DESCRIPTION TORQUE VALUE
M3 POZI PAN 2-3 Nm
M4 POZI PAN 3-4 Nm
M5 SKT HD CAP 4-5 Nm
M5 POZI PAN 4-5 Nm
M6 HEX HD 9-10 Nm
M6 BUTT HD 9-10 Nm
M6 SKT HD CAP 9-10 Nm
M8 HEX HD 15-20 Nm
M8 SKT HD CAP 15-20 Nm
M8 SKT BUTT HD 15-20 Nm
M10 HEX HD 20-25 Nm
M10 SKT BTT HD 20-25 Nm
SPECIFIC TORQUE SETTINGS
Front Wheel Axle Bolt 32 Nm
Rear Wheel Hub Studs 25 Nm
Seat Stem Height Bolts 20 Nm
To Next Page
Loading...
Need help?
General
