12
EN
SAFETY INSTRUCTIONS
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY WHEN USING
ELECTRICAL TOOLS, OPERATORS SHOULD ALWAYS OBSERVE BASIC SAFETY
PRECAUTIONS AS WELL AS THE THOSE INDICATED IN THIS MANUAL.
Read c
arefully all the instructions before use this product and keep them safe for future reference.
Operations carried out using a power tool can become dangerous for the operator if safe and adequate operating
standards are not observed. As with any electrical machinery with moving parts, use of the tool entails certain
risks.
If the tool is used as indicated in this manual, with due concentration on the work being performed, in observance
of safety regulations and wearing appropriate personal protective equipment, the risk of accidents and injury is
almost inexistent. Possible residual risks include:
1.
injury caused by direct or indirect contact with live parts.
2.
injury caused by contact with rotating pa
rts
3.
injury caused by contact with sharp pa
rts
4.
injury caused by flying parts of the tool or the material being handled
The safety equipment envisaged on tools, such as guards, casings, workpiece pusher, clamping devices and
personal protective equipment such as goggles, dust masks, ear defenders, safety footwear and gloves can help
reduce the risk of injury. However, not even the best safeguards can protect against a lack of common sense or
failure to operate with due care and attention. Always use your common sense and take all necessary precautions.
Only perform operations which you are sure are safe. DO NOT FORGET: safety is everyone’s responsibility.
This tool has been designed for a specific use. We urge you not to modify it or use it for any purpose other than
those for which it was specifically designed and built. In the event of any doubt concerning specific applications,
DO NOT use the tool until you have contacted us and received the necessary clarification.
READ AND KEEP THIS MANUAL
PERSONNEL AUTHORIZED TO USE THE MACHINE
This machine has been designed and manufactured to be used by qualified personnel with adequate training,
experience and skills. Below you will find a list of basic requirements:
Operators / Trainees / Apprentices:
may be male or female
must be aged
14 or over
must have full use of both hand
s
must have no physical or mental disabili
ties
must know and fully understand the contents of the user manual
.
To Next Page
Loading...
Need help?
General
