Oven ControlFunctions
READ THE iNSTRUCTiONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar
with the various functions of the oven as described below. Note: Control panel graphics may vary from those shown.
CLEAR PAD-- Used to clear any function
previously entered except the time of day and
minute timer. Push CLEAR to stop cooking. Also
the CLEAR pad is used to activate oven door
_ockout setting. \\
\
\
BAKE PAD--Used to _ \\
select the bake
function, _ ®
BROIL PAD--
Used to select the
variable broil
function,
\
\
\
CLEAN PAD-- Used to
select the self-c}eaning
cycle.
UP and DOWN ARROW PADS-- Used a}ong with the
function pads to select oven temperature, cooking time,
stop time (when programming an automatic stop time),
time of day, clean time and minute timer.
\
'\
Q Oven • •
::::':,:,,o,
/
• . !$elf-Cleanlng Oven , . /
,/
OVEN, PREHEAT & LOOK LIGHTS-- The "OVEN" light will glow each time the oven
turns on to maintain the set oven temperature. The "PREHEAT" light will glow when the
oven is first set to operate, or if the desired temperature is reset higher than the actual
oven temperature, The "DOOR LOCKED" light will flash when the oven door locks and
unlocks or when using the self-clean cycle or the oven door }ockout mode is activated.
The indicator light will glow constant}y after the door }ocks.
CLOCK PAD-- Used to
set the time of day,
/
FEATURE INDICATOR
LIGHTS-- These light
/
/ to show which feature
is in use,
BAKE TIME PAD-- Used
/ to enter the }ength of the
baking time (if equipped).
STOP TiME PAD-- Used
to set the desired stop
time for baking. Can be
used with BAKE TiME to
program a delayed bake
cyc}e (if equipped),
TIMER PAD-- Used to set or cancel
the minute timer. The minute timer
does not start or stop cooking. Also,
the TIMER pad is used to set the
Continuous Bake feature.
The oven can be programmed to: BAKE, TIME BAKE, BROIL, SELF-CLEAN, CONTINUOUS BAKE
and set for OVEN LOCKOUT.
For a silent control panel:
When choosing a function, a beep will be heard each time a pad is pressed. Ifdesired, the controls can be programmed for silent
operation. Press and hold _. After 7 seconds, the control will beep once. This will block the controls from sounding when
a pad is pressed. To return the sound, press and hold _ again for 7 seconds until the control beeps once.
Note: The control will return to the audible mode after a power outage.
Temperature conversion:
The electronic oven control is set to operate in °F (Fahrenheit) when shipped from the factory. The oven can be programmed
for any temperature from 170°F to 550°F (65°C to 287°C).
To change the temperature to °C (Celsius) or from °C to °F (control should not be in a Bake or Clean mode):
1. Press _. " "appears in the display.
2. Press and hold the O until "HI" appears in the display.
3. Press and hold until °F or °C appears in the display.
4. Press the O or 0' to change °F to °C or °C to °F.
5. Press any control pad to return to normal operating mode.
10
To Next Page
Need help?
General
