10
problem reas on solution
Lack of water
Turn off the unit and add water to
<FULL> level, then re-start the unit.
< > is on
Too many ice cube in the
basket
Remove the ice cube in the basket
The water reservoir has
The inlet solenoid valve
breakdown
Need the technical service pers on to
maintain
<E1> is on
Ambient temp sensor
breakdown
The unit can still work, change a new
sensor
<E2> is on
Refrigerating tube sensor
breakdown
The unit can still work, change a new
No water in the water
separator pipe
The ho les are blocked
Use slim wire to prick each hole, till
the water can flow out easily.
Ice cu be thick and cann’t
Ice making cycle too long
Press <-> to reduce the ice mking
time.
Ice cube thin
Ambient temp too high Move the unit to cool place
Water temp too high
The water temp should be no more
more than 77℉
Ice making short
Press <+> to increase the ice making
。
Unit work but no ice cube
Ambient temp is high or the
Move the unit to somewhere ambient
temp lower than 86℉,fill cool water.
Refrigerant s ystem
leakage
Need the technical service pers on to
maintain
Refrigerant system block
Need the technical service pers on to
maintain
TROUBLESH OOTING