8
BEFORE SETTING OVEN CONTROLS
Removing and Replacing the Glide Racks
The fully extendable Glide rack makes food preparation
easier. This oven rack has glide tracks that allow the rack to
be pulled away from the oven without rubbing the sides of
the oven wall.
To remove - Using one hand, reach through handle
opening and lift up on the release lever located across the
lower front of the rack as shown in
Figure 2.
While holding up the release lever, pull the glide rack out of
the oven until the stop position is reached (
Figure 3)
Using both hands, grasp the upper and lower portions of the
glide rack. Lift up the front of the rack slightly and continue
to pull the rack away from the oven (
Figure 4). Be sure to
grasp both upper and lower rack portions together when
removing or handling the glide rack.
The rack portions move independently and are difficult to
handle unless held together.
To replace - Grasp both upper and lower portions of glide
rack, lift and hold the rack level between the oven cavity
walls. Tilt the front of the rack upward slightly and slide the
rack completely into position.
Important: To prevent possible damage to the oven, do not
attempt to close the oven door until all the oven racks are
fully positioned back inside the oven cavity.
Figure 2: Grasp handle and lift up on bar
Figure 3: Pull rack to stop position
Figure 4: Remove and replace using both hands
Do not line the oven walls, racks, bottom or any other
parts of the oven with aluminum foil or with any other
materials or oven liners. Doing so will alter heat distribu
-
tion and may cause permanent damage to the oven
interior. During clean the oven temperatures will be hot
enough to melt foil.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
