Fax
4
4 Fax
194
1 Press a one touch button. Confirm that the
recipient (fax number) specified with the one
touch button is displayed on the touch
screen.
Important • The one touch buttons have a sensor to detect which page of one touch buttons (1 - 24, 25 -
48, 49 - 72) is currently opened. Before pressing a one touch button, turn over the one touch
panel completely, and take your hand off from the panel. Do not press the button while you
are turning over the panel.
• Do not place any objects near the one touch buttons or spill any liquid over them.
Note • Turn the one touch panel over to press the one touch buttons 25 and above.
• If you have entered an incorrect value, press the <C (Clear)> button and enter the correct
value.
2 Press the <Start> button.
3 Confirm the destination displayed on the touch screen, and then select [Yes].
Resolution (Specifying the Scanning Resolution)
You can set the resolution for the documents to be scanned.
Note • The machine scans a document at the specified resolution, but if the recipient's machine
does not support the resolution, the machine automatically changes the resolution to one
supported by the recipient's machine and there is a corresponding loss in quality.
• The higher the resolution, the lower the transmission speed. Usually, we recommend that
you select [Superfine (400 dpi)] or lower.
• Only [Fine (200 dpi)] is available for the Server Fax service.
You can specify the resolution for each address number. For information on how to register address
numbers, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
One touch buttons
<Start> button
To Next Page
Loading...
Need help?
General
