En-2
(1) Intake grille
(2) MANUAL AUTO button: This is used to operate it while remote
controller is not available.
(3) Front panel
(4) Vertical airfl ow direction louver
(5) Horizontal airfl ow direction louver (behind Vertical airfl ow direction
louver)
(6) Remote Control Signal Receiver: This is the place to receive the
signals from the remote controller.
(7) OPERATION Indicator Lamp (green): It lights on while operating.
(8) TIMER Indicator Lamp (orange): It lights on while timer is working.
(9) FILTER Indicator Lamp (red): It lights on if the fi lter became dirty.
Clean the fi lter referring to "CLEANING AND CARE". It lights off
when RESET button is pressed after cleaning.
(10) Drain Hose
(11) Air Filter
(12) Air cleaning fi lter
(13) Human sensor
Control unit (optional)
Types of remote controllers:
● Wireless remote controller
● Wired remote controller
● Simple remote controller
For operation method, please refer to the Operating Manual of each
device.
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the remote controller is
lost or otherwise unavailable.
CAUTION
Do not press the MANUAL AUTO button with wet hands or pointed ob-
jects, otherwise an electric shock or malfunction may occur.
Starting Operation
Press the MANUAL AUTO button on the operating
control panel.
The operation can be set in the following setting.
Operating mode AUTO:
When Auto mode cannot be selected, it will
operate in the same mode as the other indoor
unit in the same system. (When other indoor
unit in the same system doesn’t operate, the air
conditioner will operate in cooling.)
Fan speed AUTO
Setting temperature 74°F (23°C)
Stopping Operation
Press the MANUAL AUTO button on the operating
control panel.
Emergency Heat
* It is available when this function is enabled. Please consult an autho-
rized service personnel as to whether this function is effective.
Set emergency heat
During heating operation, press the MANUAL AUTO
button on the operating control panel.
Auxiliary heater will be primary heater, and the outdoor unit will stop.
The OPERATION Indicator Lamp (Green) blinks during emergency heat-
ing operation. (3 seconds on, 1 second off.)
Cancel emergency heat
During emergency heating operation, press the MAN-
UAL AUTO button on the operating control panel.
AIRFLOW DIRECTION
Vertical airfl ow direction
The vertical wind direction can be
controlled with the remote control-
ler.
1
1
2
2
3
3
4
4
Cooling
and Dry
Heating
Horizontal airfl ow direction
The horizontal airfl ow direction
can be controlled with the remote
controller.
3
4
5
2
1
9377772411-01.indb 29377772411-01.indb 2 8/30/2019 10:19:42 AM8/30/2019 10:19:42 AM
To Next Page
Loading...
Need help?
General
