En-8
8. OTHER OPERATIONS
8.1. Powerful operation
In the Powerful operation, the air conditioner will operate at maximum
power and strong airfl ow to cool down or warm up the room quickly.
Press to activate/deactivate the Powerful operation.
When activated, the indoor unit will emit 2 short beeps.
When deactivated, the indoor unit will emit 1 short beep.
The Powerful operation will be turned off automatically in the following
situations:
• The Powerful operation runs for a certain amount of time and the
room temperature reaches the set temperature in the Cooling, Dry,
or Heating mode.
• 20 minutes after the Powerful operation has started.
NOTES:
• The airfl ow direction and the fan speed are controlled automatically.
• The Powerful operation cannot be performed simultaneously with
Economy operation.
• The Powerful operation overrides the following operations. If the
following operation is set, they will start after the Powerful operation
fi nishes.
- Outdoor Unit Low Noise operation
- Energy Saving program
• If the wired remote controller (optional) is connected, this function is
restricted.
8.2. Outdoor Unit Low Noise operation
The Outdoor Unit Low Noise operation lowers noise from the outdoor
unit. During this operation, the rotation number of the compressor
decreases and the outdoor unit fan rotates slowly.
Press to activate/deactivate the Outdoor Unit Low
Noise operation.
While the Outdoor Unit Low Noise operation is activated,
on the remote controller is displayed.
The setting is preserved even if the air conditioner is turned off .
NOTES:
• This operation cannot be performed simultaneously with the Fan
mode, Dry mode, and Powerful operation.
• If the wired remote controller (optional) is connected, this function is
restricted.
8.3. Min. (Minimum) Heat operation
Min. Heat operation maintains the room temperature at 50 °F (10 °C) so
as to prevent the room temperature to drop too low.
Press to activate the Min. Heat operation.
The indoor unit will emit 1 short beep and [ ] indicator on the
indoor unit will turn on.
Press to turn off the air conditioner.
[ ] indicator will turn off .
NOTES:
• During the Min. Heat operation, only
and
are valid.
• When the room temperature is warm enough, this operation will not
perform.
• If the wired remote controller (optional) is connected, this function is
restricted.
9. WIRELESS LAN CONTROL
This operation manual describes only the setting procedure of the
remote controller.
For how to operate the mobile app, refer to the operation manual of the
mobile app.
NOTES:
• The air conditioner settings from the mobile app will not be refl ected
in the wireless remote controller.
• It will not be possible to operation and monitor by the mobile app
while the power supply of the air conditioner is disconnect (via
breaker or plug).
• The room temperature will be displayed in the mobile app during
operation. However, the displayed room temperature may not be
correct depending on the situation in the room, or the air conditioner
operating status. Use this only as a reference.
• If the mobile app and remote controller settings diff er, the latest
operation performed will take priority.
• If timer settings are done from the mobile app and from the wireless
or wired remote controller, both timer settings will be active.
The contents of wireless LAN label is necessary for wireless LAN setup.
Write down the SSID and the PIN code to the following table.
MAC: ½½½½½½½½½½½½
SSID :AP-WF½½-½½½½½½½½½½½½
PIN: ½½½½½½½½
Wireless LAN label
Refer to
page 11
.
Information on W-LAN adapter
SSID
PIN
Wireless LAN-compatible
standard
IEEE802.11b/g/n
Frequency bands
2.4GHz
1ch~11ch
Maximum radio-frequency
power
40mW
Wireless LAN security
Open
WEP
WPA (PSK)
WPA2_Personal (PSK)
WPS for same-LAN Registration
Google Play is a registered trademark of Google Inc.
App store is a service mark of Apple Inc., registered in the U.S. and
other countries.
9387602098OM.indb89387602098OM.indb8 2022/09/2619:41:402022/09/2619:41:40
To Next Page
Loading...
Need help?
General
