En-4
2.2. Indoor unit
: The instruction is relating to the wireless LAN control (optional).
Indicator lamps
*2)
Remote controller
signal receiver
Intake grille
*1)
W-LAN
adapter slot
Horizontal airfl ow
direction louvers
Drain hose
Air fi lter
Rating label
Front panel
For Manual Auto operation
and Filter indicator reset
(Refer to page 9.)
*1) Before starting operation, make sure that the intake grille is closed
completely. Incomplete closing may aff ect the proper function or
performance of the product.
*2) Indicator lamps light in the following conditions.
Name
Color Operation or condition
Operation Green Normal operation
Timer Orange Timer operation
Economy Green Economy operation
W-LAN Orange Wireless LAN control is active.
3. BASIC OPERATIONS
■
3 steps to start operation
1.
Press
to start or stop the operation.
2.
Press
to select the operation mode.
The operation mode changes as follows.
AUTO COOL DRY FAN HEAT
3.
Press
to set the desired temperature.
The temperature changes by 1 °C increments.
Temperature setting range
Auto/Cooling/Dry 18 - 30 °C
Heating 16 - 30 °C
NOTES:
• In the Cooling or Dry mode, set the temperature lower than the
current room temperature.
• In the Cooling mode, the indoor unit fan may stop from time to time
to perform Fan control for energy saving that enables power-saving
operation by stopping the rotation of the indoor unit fan when the
outdoor unit is stopped.
In initial setting, this function is activated.
To deactivate the function, consult the installer or authorized service
personnel.
• In the Heating mode,
- set the temperature higher than the current room temperature.
- at the beginning of the operation, the indoor unit fan rotates at very
low speed for 3-5 minutes.
- the Automatic defrosting operation overrides the Heating operation
when necessary.
• In the Fan mode, temperature control is not available.
4. AIRFLOW SETTINGS
4.1. Fan speed setting
)
Press to control the fan speed.
The fan speed changes as follows.
AUTO HIGH MED LOW QUIET
When is selected, the fan speed depends on the operating
condition.
4.2. Airfl ow direction setting
For details of the airfl ow ranges, refer to "Airfl ow direction
range".
■
Vertical airfl ow direction setting
)
Press to adjust the vertical airfl ow direction.
■
Horizontal airfl ow direction setting
CAUTION
Before you adjust the horizontal airfl ow direction, make sure
that the vertical airfl ow direction louver has been stopped
completely.
)
Adjust two knobs by hand.
■
Swing operation setting
)
Press to start or stop the Swing operation.
NOTES:
● The Swing operation may stop temporarily when the indoor unit fan
is rotating at very low speed or is stopped.
■
Airfl ow direction range
Vertical airfl ow direction
1
2
3
4
5
6
Change by
1
⇄
2
⇄
3
⇄
4
⇄
5
⇄
6
Swing operation by
Cooling, Dry 1 4
Heating 3 6
Fan * 1 4 or 3 6
* the Swing operation range depends on the airfl ow direction set before
the Swing operation.
NOTES:
• Do not adjust the airfl ow direction louvers by hand.
• In the Auto or Heating mode, the airfl ow direction stay position 1 for
a while from the start of the operation.
• In the Cooling or Dry mode, position 1-3 is recommended to prevent
condensation drips damaging your property. If position 4-6 keeps for
30 minutes or more in these modes, the airfl ow direction changes to
position 3 automatically.
• When using the mobile app (optional wireless LAN control is
necessary), the vertical airfl ow can be selected from 4 positions.
9333892009_OM.indb 49333892009_OM.indb 4 12/21/2018 2:34:03 PM12/21/2018 2:34:03 PM
To Next Page
Loading...
Need help?
General
