To Next Page

To Previous Page

9-2. Custom code setting for wireless remote controller

To interconnect the air conditioner and the wireless remote controller, assignment of the custom

code for the wireless remote controller is required.

NOTE:

Air conditioner cannot receive a custom code if the air conditioner has not been set for

the custom code.

1. Press the MODE button for at least 5 seconds to display the current custom code. (Initially

set to

2. Press the SET TEMP. ( or ) button to change the custom code between → → → .

Match the code on the display to the air conditioner custom code.

3. Press the MODE button again. The custom code will be changed.

NOTES:

• If no button is pressed within 30 seconds after the custom code is displayed, the system re-

turns to the original clock indicator. In this case, start again from step 1.

• The air conditioner custom code is set to prior to shipment. To change the custom code,

contact your retailer.

• The remote controller resets to custom code when the batteries in the remote controller are

replaced. If you use a custom code other than code , reset the appropriate custom code af-

ter replacing the batteries. If you do not know the assigned code for the air conditioner, try

each of the custom code ( → → → ) until you find the code which operates the air condi-

tioner.

- 21 -

WALL MOUNTED

ASYG07-12LLCE

Fujitsu ASYG07LLCE Design & Technical Manual

Other manuals for Fujitsu ASYG07LLCE