10
5. Open the ADF paper chute (cover) of the ScanSnap.
The ScanSnap is powered on and the [Scan] button lights
in blue.
6. Check the ScanSnap Manager icon.
The ScanSnap Manager icon is displayed in the menu that
appears when you click on the notification area, at the far right
of the taskbar.
To have the ScanSnap Manager icon always displayed on the
notification area, drag the icon and drop it onto the notification
area.
The ScanSnap Manager icon appears in the Dock.
ATTENTION
The bottom of the ScanSnap may become hot when the
ScanSnap is used, but this heat does not affect operation
or cause any physical harm. However, be careful not to
drop the ScanSnap when carrying it.
When the ScanSnap is turned on and left unused for 4
hours, it will turn itself off automatically. To turn the
ScanSnap back on, perform one of the following
operations:
- Press the [Scan] button (Scanning does not start).
- Close the ADF paper chute (cover) and open it again
The time until power-off can be changed. For details, refer to
the Basic Operation Guide.
HINT
When you close the ADF paper chute (cover), the
ScanSnap will turn off.
ATTENTION
If the ScanSnap Manager icon is , right-click on and select [To establish connection] from the
menu. You can reference the appropriate actions for connecting the scanner.
ATTENTION
If the ScanSnap Manager icon is , while holding down the [control] key, click and then select
[To establish connection] from the menu. You can reference the appropriate actions for connecting
the scanner.
[Scan] Button
ADF Paper Chute (cover)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
