15
2. INITIAL SETUP
Vessels equipped with SC-50/60/110/120
For better results when using the target analyzer function, an appropriate time need
to be set in the [SMOOTH S/C] menu. When the time set in this menu is too long, the
landmass can be judged as approaching target and displayed in red while accelerat-
ing, decelerating or turning. If this symptom occurs too often, shorten the time in
[SMOOTH S/C] menu.
Note: Instability of COG and SOG can be larger when the [SMOOTH S/C] time be-
comes shorter. Set the time avoiding the influence to other navigational equipment,
such as GPS plotter and autopilot.
Installation with Multi Function Displays
This radar series is compatible with the FURUNO Multi Function Displays and soft-
ware version combinations shown below. Combination with other models may not op-
erate properly.
• TZT9, TZT14 and TZTBB: Version 6.01 or later
TZTL12F and TZTL15F and TZT2BB: Version 6.21 or later
TZT12F, TZT16F and TZT19F: Version 1.05 or later
Turn on the antenna unit and FURUNO Multi Function Display. Initial setup for this an-
tenna must be done on the FURUNO Multi Function Display.
Before turning on the radar, be sure no one is near the antenna.
Prevent the potential risk of being struck by the rotating antenna, which
can result in serious injury or death.
WARNING
The radar antenna emits electromagnetic radio frequency (RF)
energy which can be harmful, particularly to your eyes. Never
look directly into the antenna aperture from a close distance
while the radar is in operation or expose yourself to the
transmitting antenna at a close distance.
Distances at which RF radiation levels of 100, 50 and 10 W/m
2
exist
are given in the table below.
N/A
XN10A
0.7 mN/A
100 W/m
2
50 W/m
2
10 W/m
2
Radiator
XN12A
XN13A
N/A 0.6 mN/A
N/A 0.4 mN/A
100 W/m
2
50 W/m
2
10 W/m
2
Radiator
XN12A
XN13A
0.2 m 1.9 m0.5 m
0.15 m
1.8 m
0.4 m
DRS6A-NXT
DRS12A-NXT
100 W/m
2
50 W/m
2
10 W/m
2
Radiator
XN12A
XN13A
0.3 m 2.8 m0.47 m
0.2 m 2.65 m0.3 m
DRS25A-NXT
To Next Page
Loading...
Need help?
General
