10-3
6. After you select all items desired, press
the soft key LOAD DATA to load data. The
following message appears.
NOW LOADING DATA FROM
MEMORY CARD. DO NOT
TURN OFF THE POWER UNTIL
LOADING COMPLETE.
Figure 10-8 LOAD DATA message
After loading is completed, the following
message appears.
COMPLETE LOADING DATA.
PRESS "ENTER" KEY
TO CONTINUE.
Figure 10-9 COMPLETE message
7. Press the [ENTER] key.
Note on loading data
Track
Since loaded track data is added to internal
track, oldest track will be entered when the
track memory capacity is exceeded.
Waypoint/route
The loaded data substitutes for previously
stored.
Mark/line
The loaded data is added to internal data.
When the mark/line memory becomes full no
marks may be entered.
Configuration
The loaded data replaces current configura-
tion settings. Press the [ENTER] key to re-
start. If the memory card is ejected while
loading or data could not be loaded, press
the [ENTER] key to restart with default set-
tings. Note that track memory capacity is not
saved or loaded.
To Next Page
Loading...
Need help?
General
