To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...What to do if Furuno Marine GPS System locks up after clearing memory?
If the Furuno Marine GPS System locks up after clearing the GPS and plotter memories, reapply power to the equipment. This should restore normal operation.
What to do if Furuno GP-80 GPS locks after clearing memories?
If your Furuno GPS equipment locks up after clearing the GPS and plotter memories, reapply power to the equipment to restore normal operation.
General| Power Supply | 12-24 VDC |
|---|---|
| Update Rate | 1 second |
| Operating Temperature | -15°C to +55°C |
| Channels | 12 |
| Routes | 50 |
| Display Type | LCD |
| GPS Receiver | 12 channels |
| Frequency | L1 (1575.42 MHz) |
| Display | Color LCD |
| Type | GPS Navigator |
| Waypoints | 1000 |
Provides details on how to operate the DD-80 unit, including control functions and power management.
Explains the function of each key on the control panel for user interaction.
Details the procedure for powering the unit on and off, including initial startup sequence.
Guides on entering waypoints by cursor, MOB/event position, own ship, or list.
Explains how to modify existing waypoint details.
Details how to delete waypoints by cursor or through the waypoint list.
Describes how to create routes by linking waypoints for navigation.
Covers four methods to set a destination waypoint or route.
Explains how to cancel the currently set destination.
Explains how to customize the data displayed on the screen.
Explains how to set and manage arrival and anchor watch alarms.
Details how to set the alarm for deviating from the intended course.
Describes how to configure alarms for ship speed exceeding or falling below set limits.
Explains how to set an alarm for exceeding a specified trip distance.
Covers GPS settings like fix mode, satellite disabling, and smoothing.
Describes how to configure data output to external equipment via ports.
Guides on loading and saving waypoint/route data to/from a PC.
Explains how to set up the DGPS receiver to select a station.
Provides procedures for clearing plotter, GPS, or both memories.
Offers solutions for common operational problems and issues.
Explains initial setup procedures, including talker IDs and data formats.
