2020
2 CHANNEL AMPLIFIER
1 POWER AND STATUS LED’S:
This displays ‘green’ if the amplifier has been correctly powered up and ‘red’ if any faults are present.
2 CROSSOVER SELECTOR:
Set the appropriate mode of operation. The three positions available are OFF, LP and HP.
See points 3 and 4 below.
3 LOW PASS:
Set the crossover switch 2 to LP when a subwoofer is connected. Ensure the crossover frequency is set
at 100Hz or below. This feature is designed to filter out all mid to high frequencies that only full range
speakers should produce.
Note: Failure to do so could result in speaker damage.
CONTROL DESCRIPTIONS
EN-AM3002, EN-AM4502
8
9
10
11 12
1 2 3 4 5 6 7
To Next Page
Loading...
Need help?
General